Barco R59116700-01 Manuale Utente
8
Introduction
1.6.3
Unpacking
WARNING
:
The ECU-100 chassis is heavy, lifting precautions should be taken.
Inspect items for damage. Should any items show any signs of damage, report it immediately to
your vendor.
your vendor.
IMPORTANT
:
The ECU-100 contains additional packaging inside the chassis.
This MUST be removed prior to operation by removing the chassis lid via the 2 screws located on each side of
the case.
This MUST be removed prior to operation by removing the chassis lid via the 2 screws located on each side of
the case.
Retain packaging materials for future transit requirements.
1.6.4
Installation precautions
•
Do not place this unit on an unstable cart, stand, or table. The unit may fall, causing
serious damage to it.
serious damage to it.
•
Do not use this unit near water.
•
Use only the power cord supplied with your unit. While appearing to be similar, other
power cords have not been safety tested at the factory and may not be used to power
the unit. For a replacement power cord, contact your dealer.
power cords have not been safety tested at the factory and may not be used to power
the unit. For a replacement power cord, contact your dealer.
•
Slots and openings in the cabinet and the sides are provided for ventilation; to ensure
reliable operation of the unit and to protect it from overheating, these openings must
not be blocked or covered. The openings should never be blocked by placing the prod-
uct on a bed, sofa, rug, or other similar surface. This product should never be placed
near or over a radiator or heat register. This unit should not be placed in a built-in instal-
lation or enclosure unless proper ventilation is provided.
reliable operation of the unit and to protect it from overheating, these openings must
not be blocked or covered. The openings should never be blocked by placing the prod-
uct on a bed, sofa, rug, or other similar surface. This product should never be placed
near or over a radiator or heat register. This unit should not be placed in a built-in instal-
lation or enclosure unless proper ventilation is provided.
•
The maximum recommended ambient temperature for this equipment is 40° C.
•
When using the unit in a multi-unit rack assembly or closed assembly the ambient
temperature inside the assembly may not succeed the maximum rated ambient tem-
perature.
temperature inside the assembly may not succeed the maximum rated ambient tem-
perature.
•
When installed in a rack, the installation should be such that the amount of air flow
required for safe operation of the equipment is not compromised. The mounting of the
equipment should be such that no hazardous condition is achieved due to uneven
mechanical loading.
required for safe operation of the equipment is not compromised. The mounting of the
equipment should be such that no hazardous condition is achieved due to uneven
mechanical loading.