Husqvarna 966451906 Manuale Utente

English - 

43

 

1.  Thread the throttle cables in the connection M 

as outlined in figure 55. NOTE! The figure is 

shown from underneath.

2.  Run the fuel hose D through hole K and hoses 

B and C in hole L. See figure 55. Pull the hoses 

so that the collars are on each side of the bot-

tom on the carburettor compartment.

3.  Tighten the chain catcher in place.
4.  Press the movement limiter H into position. See 

figure 53. 

5.   Tighten the screws F. See figure 51.
6.  Hook on the throttle cable E in the intake bellow. 

See figure 50. 

7.  Fit the tank unit. The two short screws are fitted 

to the bottom of the handle bar.

8.  Assemble the carburettor as outlined in “Assem-

bling the carburettor”. Assemble the air filter 

and cylinder cover.

Repair Instructions

1.  Dismantle the following parts:
  • Bar and chain. See the Operator’s Manual.
  • Cylinder cover. See the Operator’s Manual.
  • Tank unit and handle. See “Dismantling the 

tank unit”.

2.  Dismantle the spring on the handle bar using a 

4 mm Allen key (see figure 57).

3.  Dismantle the springs on the tank unit using 

a 4 mm Allen key (tool 502 50 18-01). See 

figure 57. 

Clean and inspect all parts.

1.  Fit the springs on the handle bar using a 4 mm 

Allen key (tool 502 50 18-01).

2.  Assemble the following parts:
  • Tank unit and handle. See “Assembling the 

tank unit”.

  • Cylinder cover. See the Operator’s Manual.
  • Bar and chain. See the Operator’s Manual.

Fig 55

Fig 54

Fig 56

Fig 57