Husqvarna 966451906 Manuale Utente

English - 

49

Repair Instructions

Dismantle the following:

•  The clutch cover
•   The chain and bar.
•   The centrifugal clutch *
•   The cylinder cover
•   The starter *
•  The flywheel *
•   The carburettor *
•   The bottom of the carburettor *
•   The hand guard *
•   The muffler *
•   The handle system *
•  The fuel unit *
•   The piston and cylinder *
•  The ignition module
•  Cabling
•  The oil pump
* See specific instruction.

x4

Fig 69

Fig 70

Fig 71

If required, remove the circlip on the flywheel side.

Remove the 5 screws from the pulley wheel side.

See Figure 69.

Fit tool 575 28 69-01 as outlined in figure 70.

Remove the crankcase half on the clutch side.

Fit tool575 28 69-01 as outlined in figure 71. 

Remove the flywheel side’s crankcase half.

Carefully pull the crankcase halves apart. Two 

guide pins keep the crankcase halves together. Lift 

out the connecting rod and dispose of the gasket.