Husqvarna 966451906 Manuale Utente

54

 - English

Repair Instructions

Empty the oil tank.

Knock in the old bar bolts from the outside so that 

they end up in the oil tank.

Remove the bolts from the oil tank.

Attach a wire to the head of the bar bolt, lower the 

wire through the oil tank and out through the bolt 

opening in the crankcase. See figure 83.

Pull out the bar bolt so that it protrudes from its 

opening. See figure 83.

Pull out the bar bolt with its nut. Insert a spacer 

between the nut and the crankcase. See figure 83.

Fill with chain oil.

If threads on the chainsaw are worn, the repa-

ration kit, 503 27 33-01, is available.

First drill with:

  6.1 mm drill for the magnesium crankcase
Then screw in the thread plug using a suitable 

screw and wrench.

This type of screw plug is ideal for plastic 

and magnesium but cannot be used to repair 

threads in aluminium. There is another type of 

thread plug and metric screw available for this 

purpose. See figure 84. Check the manufac-

turer’s manual for thread information.

Fig 84

Fig 83