Dolmar PS6400 Manuale Utente

24

cool off before refuelling!
Thoroughly  clean  the  area  around  the  caps,  to  prevent  dirt  

from getting into the fuel or oil tank.
Unscrew  the  cap  and  fill  the  tank  with  fuel  (fuel/oil  mixture) 

or chain oil as the case may be. Fill up to the bottom edge  

of the filler neck. Be careful not to spill fuel or chain oil!
Tightly screw on the cap.
After refuelling, clean screw cap, tank and check for le-

Lubricating the chain
During operation there must always be sufficient chain oil in 

the chain-oil tank to provide good chain lubrication. One filling 

is sufficient for about one half-hour of continuous operation. 

While working make sure there is enough chain oil in the tank. 

If necessary, add oil. The engine must be switched off!  

Waste oil is very dangerous for the environment.
Waste oil contains high amounts of carcinogenic substances.
Residues in waste oil result in a high degree of wear and tear 

at the oil pump and the sawing device.
In case of damage caused by using waste oil or unappropriate 

chain oil the product guarantee will be null and void.
Your salesman will inform you about the use of chain oil.

Mineral oil products degrease your skin. If your skin comes in 

contact with these substances repeatedly and for an extended 

period of time, it will desiccate. Various skin deseases may result. 

In addition, allergic reactions are known to occur.
Eyes can be irritated by contact with oil. If oil comes into your 

eyes, immediately wash them with clear water.
If your eyes are still irritated, see a doctor immediately!

age to the oil pump or other parts.
The next time you use the saw, fill the tank with BIOTOP 

chain oil again.

 

In case of damage caused by using waste 

oil or unappropriate chain oil the product guarantee will be 

null and void.
Your salesman will inform you about the use of chain oil.

If you are not planning to use the saw again for an ex-

tended period of time, empty the oil tank and put in a small 

amount of regular engine oil (SAE 30), and then run the 

saw for a time. This is necessary to flush out all remain-

ing bio-degradable oil from the oil tank, oil-feed system, 

chain and guide bar, as many such oils tend to leave sticky 

residues over time, which can cause dam-