Husqvarna 1018855-26 Manuale Utente
English –
115
Press out the crankshaft by using tool
502 51 61-01.
502 51 61-01.
!
WARNING!
The crankcase halves can be
hot. Risk of burns. Wear protec-
tive gloves.
The crankcase halves can be
hot. Risk of burns. Wear protec-
tive gloves.
If necessary remove the crankshaft
bearing from the crankcase.
Proceed as follows:
bearing from the crankcase.
Proceed as follows:
If necessary remove the following parts:
A.
Chain tension screw
B.
Bar bolts
C.
Spike
Remove the bearing from the crankshaft
using puller 502 90 90-01.
using puller 502 90 90-01.
Split the shaft support and
dismantle the halves.
dismantle the halves.
If the crankshaft bearing still remains on
the crankshaft when dismantling, remove
it using puller 502 90 90-01.
the crankshaft when dismantling, remove
it using puller 502 90 90-01.
CRANKCASE AND CRANKSHAFT
Saws 36 and 41.
Saws 40 and 45.
Remove all rubber and plastic components
from the crankcase halves.
from the crankcase halves.
Heat the crankcase half in question to
200°C.
200°C.
Wear protective gloves and knock the
crankcase half gently, inside face down, on
a wooden bench or the like, and the
bearing will drop out.
crankcase half gently, inside face down, on
a wooden bench or the like, and the
bearing will drop out.
Fit the new bearing into the crankcase half
while it is still hot.
while it is still hot.
Eng, p 83-124
96-09-13, 13.03
115