IBM 343 Manuale Utente
61
5 Upgrading the Hardware
Tools and Supplies Needed
Procedures in this section require the following tools and supplies:
•
Jumper-removal tool or needle-nosed pliers
•
Small flat-bladed screwdriver
•
Phillips (cross-head) screwdriver (#2)
•
Pen or pencil
•
Anti-static wrist strap and conductive foam pad (recommended)
Figure 10. Tools and Supplies Needed
Equipment log: as you integrate new parts into the system, add information about them to your
equipment log (Appendix B). Record the model and serial number of the system, all installed
options, and any other pertinent information specific to the system.
equipment log (Appendix B). Record the model and serial number of the system, all installed
options, and any other pertinent information specific to the system.
Caution and Danger Statements
Caution and danger statements apply throughout this chapter. Only a technically qualified person
should configure the server hardware.
should configure the server hardware.
Note
System power on/off:
The power button DOES NOT switch off system
power. To remove power from the system, you must unplug/disconnect the
power connections. Make sure power connections are unplugged/
disconnected before you open the chassis, add, or remove any components.
power connections. Make sure power connections are unplugged/
disconnected before you open the chassis, add, or remove any components.