Zenoah BK2651DL Manuale Utente

GB-10

BK2651DL

• Overchoking may make the engine hard to start due

to excess fuel. If the engine fails to start after several
attempts, open the choke and repeatedly pull the rope,
or remove the spark plug and dry it before trying again.

STARTING A WARMED ENGINE
You can start a warmed engine while carrying the unit
on the back.
1. Set the ignition switch to the RUN position.
2. Release the throttle lever.
3. Set the choke lever to the Open position.
4. Hold the handle firmly with the right hand and keep

the cutter head away from surroundings such as the
ground.

5. Pull the starter grip with the left hand.

Starter grip

STARTING A COOLED ENGINE
1. Set the ignition switch to the RUN position.
2. Release the throttle lever. This lever cannot be oper-

ated unless you hold the grip firmly and push the up-
per lever as far as it goes.

3. Fill the carburetor with fuel by using the carburetor

starting pump. Repeatedly push and release the pump
with the fingers until excess fuel flows out in the clear
tube.

• The pumping operation is not required when restart-

ing the engine immediately after stopping it while fuel
remains in the tank.

4. Close the choke lever at the bottom of the air cleaner.

• Pull the starter rope while leaving the choke open if

you restart the engine immediately after the engine
stops.

Choke lever

Close

Open

Primer pump

5. Place the unit on flat, firm ground. Make sure that the

cutting head is clear of everything around it, then pull
the starter knob while grasping the main pipe with
the left hand and weighing down the frame with the
right foot.

• Do not pull all the rope at a time or return it by releas-

ing the knob. Doing so may cause a starter failure.

6. When the engine starts, open the choke gradually.
7. Allow the engine to warm up at low speed for two to

three minutes before starting operation.

(1) Ignition switch
(2) STOP
(3) RUN
(4) Throttle lever
(5) Idling
(6) Fully opened