Zenoah EXZ2610DL Manuale Utente
GB-16
EXZ2610DL
STARTING ENGINE
(HE-EX only)
The ZENOAH stick edger is designed for edging lawn in
gardens, parks, roadsides and so on.
Before starting the engine, take the operating position
and adjust the handle position and the wheel height as
necessary.
(HE-EX only)
The ZENOAH stick edger is designed for edging lawn in
gardens, parks, roadsides and so on.
Before starting the engine, take the operating position
and adjust the handle position and the wheel height as
necessary.
ADJUSTING HANDLE POSITION
• Loosen the handle bracket screws and re-position the
• Loosen the handle bracket screws and re-position the
handle to your best operating position. Re-tighten the
screws.
screws.
ADJUSTING WHEEL HEIGHT
• Loosen the clamp lever and change the wheel height
• Loosen the clamp lever and change the wheel height
to obtain desired cutting depth.
(1) Deep cut
(2) Shallow cut
WARNING
Never adjust wheel height with the engine running.
8. Operation
WARNING
The cutting head will start rotating upon the engine
starts.
starts.
1. Feed fuel into the fuel tank and tighten the cap se-
curely.
(1)
(PS-EX only) Feed the chain oil into the oil tank and
tighten the cap securely, too.
tighten the cap securely, too.
(2)
(1) Fuel
(2) Chain oil
2. Rest the unit on a flat, firm place. Keep the cutting
head off the ground and clear of surrounding objects,
as it will start rotating upon starting of the engine.
as it will start rotating upon starting of the engine.
3. Push the primer several times until overflown fuel flows
out in the clear tube.
4. Move the choke lever to the closed position.
(1)
(2)
(3)
(1) Choke lever (2) Close (3) Open