Zenoah BCZ2610DL Manuale Utente

GB-14

BCZ2610DL

• Note that using any spark plug other than those desig-

nated may result in the engine failing to operate properly
or in the engine becoming overheated and damaged.

• To install the spark plug, first turn the plug until it is

finger tight, then tighten it a quarter turn more with a
socket wrench.

• Inspect periodically, the muffler for loose fasteners,

any damage or corrosion. If any sign of exhaust leak-
age is found, stop using the machine and have it re-
paired immediately.

• Note that failing to do so may result in the engine

SPARK ARRESTER
• The muffler is equipped with a spark arrester to pre-

vent red hot carbon from flying out of the exhaust out-
let. Periodically inspect and clean as necessary with
a wire brush.

ANGLE TRANSMISSION
•   The reduction gears are lubricated by multipurpose,

lithium-based grease in the angle transmission. Sup-
ply new grease every 25 hours of use or more often
depending on the job condition.

•   Remove the bolt opposit to the grease nipple before

installing new grease to arrange for old grease to exit.

• Never touch the cylinder, muffler, or spark plugs

AIR FILTER
• The air filter, if clogged, will reduce the engine perfor-

mance. Check and clean the filter element in warm,
soapy water as required. Dry completely before in-
stalling. If the element is broken or shrunk, replace
with a new one.

FUEL FILTER
• When the engine runs short of fuel supply, check the

fuel cap and the fuel filter for blockage.

SPARK PLUG
• Starting failure and misfiring are often caused by a

fouled spark plug. Clean the spark plug and check
that the plug gap is in the correct range. For a re-
placement plug, use the correct type specified by
ZENOAH.

TIGHTENING TORQUE:

9.8 ~ 11.8 N.m.
(1 ~ 1.2 kgm)

0.6~0.7 mm

Fuel filter

Air Filter

Spark arrester