Zenoah BK4310FL-S Manuale Utente

insert the liner into the clutch housing, being careful
to make sure that the hole on the end of the liner is
facing directly upwards.  When the hole reaches a
point directly below the stopper, you will hear a
clicking sound as the stopper moves into the hole to
fix the liner into place. (SE4)

• If you experience any difficulty in inserting the liner,

pull out the liner, rotate the flexible shaft slightly, and
try inserting it again.

• Once the liner has been inserted, pull on the liner to

make sure that the stopper is properly engaged.

After connecting the inner shaft to the shaft of the main
pipe, try to pull out the flexible shaft by hand to make
sure the flexible shaft does not come off.

■ ATTACHING THE THROTTLE CABLE

• Align the throttle cable along with the liner and tie it

with band. (SE5)

1. Hook the cable and into the hole of the throttle lever.

And set the cable in the lever as shown in the picture.
(SE6)

■ ATTACHING THE SHOULDER STRAP (SE1)
1. Pass the ring of the shoulder strap through the

hook(A) and fix it by the bolt securely.

2. Set the hook(B) of each shoulder strap to the D-rings

on the frame.

■ ATTACHING THE LINER
1. Remove the bolt located on the joint of the outer

pipe. (SE2)

2. Match the groove of the liner with the threaded hole

and fix with screw securely. (SE2)

3. While rotating the flexible shaft located on the

opposite end from the liner, insert the flexible shaft
into the joint until it is tightly connected.  (Note that it
is normal at this time for the flexible shaft not to
project from the liner.) (SE3)

4. To connect the clutch housing to the liner, lay the

liner out straight, align the flexible shaft with the
angular hole on the side of the clutch drum, and