Zenoah BC3401DL Manuale Utente
■ PUTTING ON WAIST PAD
(BC4401DW only)
• Warp the waist pad around the shaft tube
(BC4401DW only)
• Warp the waist pad around the shaft tube
and the throttle wire.
■ INSTALLING CUTTING HEAD
1. While locking the gear shaft by inserting
1. While locking the gear shaft by inserting
the attached bar into the upper holder and
the gear box, loosen and remove the
hexagon bolt(left-handed)
the gear box, loosen and remove the
hexagon bolt(left-handed)
2. Fit the spacer attached to the head
assembly between the upper and lower
holders. Then screw in the cutting head to
the gear shaft over the holders. Hand-
tighten it securely.
holders. Then screw in the cutting head to
the gear shaft over the holders. Hand-
tighten it securely.
12
Set Up