Zenoah BC3401DL Manuale Utente

• Keep bystanders and animals at least 50

feet (15m) away from the operating
point. If you are approached,
immediately stop the engine.

■ STARTING ENGINE
1. Rest the unit on a flat, firm place. Keep the

cutting head off the ground and clear of
surrounding objects as it will start rotating
upon starting of the engine.

2. Pump the primer until fuel flows out in the

clear tube.

3. Move the choke lever upward to close the

choke.

4. Shift the ignition switch to the START

position.

WARNING

5. Pull the starter rope.

• The product is equipped with a

centrifugal clutch mechanism, so the
cutting attachment begins to rotate as
soon as the engine is started by putting
the throttle into the start position. When
starting the engine, place the product
onto the ground in a flat clear area and
hold it firmly in place so as to ensure
that neither the cutting part nor the
throttle come into contact with any
obstacle when the engine starts.

• Avoid pulling the rope to its end or returning

it by releasing the knob. Such actions can
cause starter failures.

6.When the engine has started, move the

choke lever gradually downward to open
the choke.

7.Allow the engine to warm up for a half

minute before starting operation.

1.When restarting the engine immediately

after stopping it, leave the choke open.

2.Overchoking can make the engine hard to

start due to excess fuel. When the engine
failed to start after several attempts, open
the choke and repeat pulling the rope, or
remove the spark plug and dry it.

NOTE

WARNING

Operation

15 