Land Pride RCP2660 Manuale Utente

Return line from motor has been pinched or
is collapsed

Replace lower seal of motor. Check motor
return hose for kinks.

Return line from motor has been pinched or
is collapsed

Replace lower seal of motor and Spindle
Hub output shaft seal. Check motor return
hose for kinks.

Contacting drawbar or Bottoming out

Reposition drawbar/Replace PTO tubes and
cut to correct length.

Cutting on sandy ground

Raise cutting height.

Contacting ground frequently

Raise cutting height.

Insufficient shimming

Add shimming. See text.

Blade bolts not tightened properly

Torque blade bolt nuts to 600 ft lbs.

Hitting solid objects

Thoroughly check the cutting area BEFORE
beginning to cut. Be alert during cutting.

Worn Spindle Hub bearings.

Replace Spindle Hub bearings and/or shaft.

Shaft nut loose

Tighten Spindle Hub shaft nut to 450 ft lbs.

Hitting solid objects

Replace / Be alert, avoid solid objects.

Cutting height not level or blade missing

Adjust deck height or replace

Soil abrasive

Raisecuttingheight.

Cutting too low

Raise cutting height.

Locked blades

Inspect and unlock blades.

Blades have unequal weight

Replace blades as a PAIR.

PTO driveline is bent

Straighten or replace PTO driveline.

Blade carrier bent

Replace/straightenbladecarrier.

PTO cross not centered with yoke

Disassemble and inspect for incorrectly
located needles or damaged bearing cap.

Orifice elbow on rod end is plugged

Clean orifice fitting.

Broken/disconnected wire on solenoid

Check wiring on cartridge valve solenoids.

Cylinder rod is bent

Replace cylinder.

Electric solenoid valve is sticking/dirty.

Remove solenoid valve and clean or
replace.