Land Pride RCR1248 Manuale Utente

12/15/15

7.

Insert properly sized linchpins (#18) in hitch pins 
(#20). (Customer to supply properly sized linchpins.)

8.

RCR1272 tailwheel A-frame (#3) is shipped 
unattached. Attach A-frame as follows:

a. Attach front end of A-frame (#3) to the deck as 

shown with 5/8"-11 x 1 3/4" GR5 bolts (#8). Do not 
install hex flange lock nuts (#14) at this time.

b. Attach back end of A-frame (#3) as shown to 

adjusting plate with 3/8"-16 x 1 1/4" GR5 carriage 
bolts (#10) and hex whiz nuts (#13). Tighten hex 
whiz nuts to the correct torque.

9.

If RCR1248 or RCR1260, remove hex flange lock 
nuts (#14) from bolts (#8). Do not remove bolts. 

10. Attach rear braces (#5) inside of tailwheel main 

frame (#3) with 5/8"-11 x1 3/4" GR5 bolts (#8) and 
secure with hex flange lock nuts (#14). Draw lock 
nuts (#14) up snug and then back off 1/4 turn.

11. Rotate A-frame/floating top hitch (#6 & #24) up and 

rotate left rear brace (#5) up as follows:

IMPORTANT: See Detail A in Figure 1-2 on page 9 
Floating top hitch (#24) must be installed with ears 
(#25) above rear brace bars (#5).

30289

IMPORTANT: Some small tractors with a Cat. I 3-point hitch cannot lift 
cutter high enough for transporting or is not heavy enough in the front to 
properly lift the cutter. If your are experiencing this problem, attach A-frame 
bars (#6) and hitch pins (#20) in lower 3-point mounting holes “B”.

a. Refer to Detail A: If attaching cutter to a 3-point 

Cat. I hitch, align holes A in rear braces (#5) with 
hole in floating top hitch (#24). 

b. Refer to Detail A: If tractor is too small to lift cutter 

high enough for transporting, align hole B in rear 
braces (#5) with hole in floating top hitch (#24).

12. Insert 3/4"-10 x 4" GR5 bolt (#9) into the left rear 

brace (#5), floating top hitch (#24), and right rear 
brace (#5). 

13. Secure bolt with hex flange lock nut (#12). Draw 

locknut (#12) up snug and then back off 1/4 turn. 

14. Install machine washer (#16) on tailwheel 

spindle (#2). 

15. Insert tailwheel spindle (#2) in tailwheel A-frame (#3). 

16. Install spacer (#1) on tailwheel spindle (#2). 

17. Insert roll pin (#23) on spindle (#2) above spacer (#1).

NOTE:  You may need to lift the cutter rear or 
remove bolts (#10) to assemble tail wheel (#2).

NOTE:  After assembly of hitch and tailwheel, push 
on top of A-frame assembly (#6). It should rotate 
backward and floating top link (#24) should rotate 
upward. If they are too stiff to rotate, loosen nut or 
nuts (#12) until top link rotates freely.