Land Pride RCR1248 Manuale Utente

12/15/15

There are 4 primary adjustments that should be made 
prior to actual field operations:

Proper adjustment of each of these items will provide for 
higher efficiency, improved cutting performance, and 
longer blade life. The following tools will be needed:

Pliable tape measure

Spirit or carpenters level

Open end or hex end wrench or socket set

Protective gloves

Figure 3-1:
1.

Locate tractor with Rotary Cutter on a flat, level 
surface.

2.

Use tractor’s hydraulic 3-point control lever to lower 
cutter until the tailwheel makes contact with the 
ground surface.

3.

Place a level on the front of the cutter deck as shown 
in Figure 3-1. Manually adjust either one or both of 
the tractor’s lower 3-point arms to level the deck from 
left to right. Some tractors have only a single 
adjusting arm. 

1.

Using tractor’s 3-point hydraulic control, raise or 
lower the 3-point arms until the front of the deck is 
slightly lower than the rear of the deck.

30295

IMPORTANT: The front blade tip should be lower 
than rear blade tip by approximately 1". The cutter is 
subject to continuous material flow under the deck if 
the rear blade is at the same height or lower than the 
front blade causing horsepower loss, grass clumps, 
blade wear, and frequent blade sharpening.

30296