Land Pride RCR1560 Manuale Utente
9
Section 1: Assembly and Set-Up
12/28/05
RCR1542, RCR1548, RCR1560 and RCR1572 Rotary Cutters 312-556M
Land Pride
Driveline Installation
Refer to Figure 1-2:
1.
Remove the snap ring (#1) from the gearbox input
shaft. Slide the driveline (#2) on to the gearbox shaft
and replace the snap ring to the gearbox shaft. The
snap ring is for extra security in case the shear bolt
(#3) should break. Align the holes in the driveline
with the hole in the gearbox input shaft and insert the
1/2” x 3 1/2” long bolt (#3) and secure with the 1/2”
nut (#4) and 1/2” jam nut (#5).
shaft. Slide the driveline (#2) on to the gearbox shaft
and replace the snap ring to the gearbox shaft. The
snap ring is for extra security in case the shear bolt
(#3) should break. Align the holes in the driveline
with the hole in the gearbox input shaft and insert the
1/2” x 3 1/2” long bolt (#3) and secure with the 1/2”
nut (#4) and 1/2” jam nut (#5).
2.
Secure the chain on the driveline to the driveline
cone to restrict outer shield from rotating.
cone to restrict outer shield from rotating.
Driveline Installation
Figure 1-2
16385
3-Point Hook-Up
Refer to Figure 1-3:
!
DANGER
Tractor hook-up can be hazardous to your health or that of
your helper. Do not allow anyone to stand between the _____
and the tractor during hook-up operations. Do not operate the
hydraulic 3-point lift controls while someone is directly
behind the tractor.
your helper. Do not allow anyone to stand between the _____
and the tractor during hook-up operations. Do not operate the
hydraulic 3-point lift controls while someone is directly
behind the tractor.
1.
Slowly back the tractor up to the cutter and use the
tractor’s 3-point hydraulic control to adjust the lower
link arms up or down to match the height of the cutter
hitch pins.
tractor’s 3-point hydraulic control to adjust the lower
link arms up or down to match the height of the cutter
hitch pins.
2.
Slide the the lower link arms hitch link holes onto the
cutter hitch pins.
cutter hitch pins.
3.
Install a linch pin or other fastener (supplied by
customer) through the hitch pin hole to lock the lower
links into position.
customer) through the hitch pin hole to lock the lower
links into position.
4.
Connect the top link to the upper pivot hitch using the
3/4" clevis pin supplied.
3/4" clevis pin supplied.
Tractor Hook-Up
Figure 1-3
16386