Land Pride RCR1272 Manuale Utente

12/15/15

30240

30291

1.

Unsnap side access covers (#4) from both sides of 
the gearbox shield. Save covers for reuse.

2.

Remove bolt (#2) from end of driveline (#5).

3.

Slide driveline (#5) onto gearbox input shaft until 
holes in driveline yoke aligns with hole in gearbox 
input shaft.

4.

Insert bolt (#2) through driveline yoke and gearbox 
input shaft. 

5.

Secure bolt with removed nut (#3). Tighten hex nut to 
the correct torque.

6.

Skip to step #8 is installing a slip clutch driveline.

7.

If driveline (#5) has a shear bolt instead of a slip 
clutch, install snap ring (#1) onto the gearbox input 
shaft groove. Discard snap ring if driveline has a slip 
clutch.

8.

Reinstall access covers (#4). 

9.

Raise driveline (#5) up and rotate driveline hook (#6) 
down. 

10. Lower driveline (#5) until resting in driveline 

hook (#6).

11. Continue with “3-Point Hook-Up” on page 12.

NOTE:  Snap ring (#1) is for extra security should 
driveline shear bolt (#2) break. Do not use snap ring 
with a slip clutch driveline.