Land Pride RC4015 Manuale Utente

10/21/15

1.

Attach center deck lift cylinder hose to a tractor. See 
Hydraulic Hook-up on page 17 for instructions.

2.

Raise cutter up with tractor control lever and remove 
shipping bracket from center deck cylinder rod. 

3.

After removal of shipping bracket, lower center deck 
completely down until it is resting on its skid shoes.

4.

Hitch (#1) is shipped hinged up and bolted in place. 
Remove and discard 1/2" hex whiz nuts (#4) and 
1/2" bolts (#3).

5.

Rotate hitch down into pulling position as shown and 
install left and right leveling rods (#1) to hitch 
frame (#2) with 3/4" x 1 1/2" clevis pins (#6), 3/4" flat 
washers (#5), and 1/8" x 1 1/4" cotter pins (#7).

6.

Bend legs of cotter pins to keep pins from falling out.

7.

Leveling rod adjustment will be made after cutter is 
attached to the tractor.

Refer to Figure 1-7:
1.

Attach park jack (#9) to jack mount and secure with 
attached pin (#8). 

2.

If park jack is not vertical, adjust jack angle according 
to “Park Jack Angle Alignment” on page 24.

3.

Adjust jack up or down until clevis hitch (#1) is at 
drawbar height.

Refer to Figure 1-7:
1.

Attach spring hose loop (#10) to A-frame hitch (#2) 
with 3/8"-16 x 1" GR5 bolt (#11), flat washer (#12), 
and hex flange lock nut (#13).

2.

Rotate spring hose loop (#10) to face forward as 
shown and tighten hex flange lock nut (#13) to the 
correct torque.

NOTE:  The center deck lift cylinder hose will need 
to be attached to a tractor before the hitch on the 
cutter can be rotated down for assembly.

The following is proper shutdown procedures. Always 
follows these procedures before dismounting tractor.

1.

If engaged, disengage PTO.

2.

Lower attached implement to ground, put tractor in 
park or set park brake, turn off engine, and remove 
switch key to prevent unauthorized starting.

3.

Wait for all components to come to a complete stop 
before leaving the operator’s seat.

37591