Land Pride RC4015 Manuale Utente
30
Section 3: Operating Instructions
RC4015 and RCM4015 Series 2 S/N 944961+ Rotary Cutters 330-845M
10/21/15
Transport Locks
Cutter wings will need to be raised before transporting on a
roadway, through narrow gate openings and when
servicing the deck underside.
roadway, through narrow gate openings and when
servicing the deck underside.
1.
Disengage tractor PTO and wait for cutter blades to
come to a complete stop before raising wings.
come to a complete stop before raising wings.
2.
Rotate cutter wings fully up with hydraulics.
3.
Place tractor gear selector in park, shut tractor
engine off or set park brake, remove switch key, and
dismount from tractor.
engine off or set park brake, remove switch key, and
dismount from tractor.
Transport Bar, Storage Position
Figure 3-3
4.
See Figure 3-3: Remove hairpin clip (#1) from
storage lug (#2).
storage lug (#2).
5.
See Figure 3-4: Rotate end of transport lock bar (#3)
to cylinder pin (#4). Secure with hairpin clip (#1).
to cylinder pin (#4). Secure with hairpin clip (#1).
6.
Repeat steps 4 and 5 for the other wing. Your cutter is
now ready for transporting.
now ready for transporting.
IMPORTANT: Always disengage tractor’s PTO &
wait for blades to come to a complete stop before
raising cutter wings to transport position. Wing
drivelines, wing gearboxes, and splitter gearbox can
be damaged if driveline is turning.
wait for blades to come to a complete stop before
raising cutter wings to transport position. Wing
drivelines, wing gearboxes, and splitter gearbox can
be damaged if driveline is turning.
NOTE: The wings are controlled with two hydraulic
lift cylinders. Be certain that the wing hydraulics are
attached to the tractor and the hydraulic hoses are
full of oil before proceeding.
lift cylinders. Be certain that the wing hydraulics are
attached to the tractor and the hydraulic hoses are
full of oil before proceeding.
27923
3
2
1
4
Transport Bar, Locked Position
Figure 3-4
Transporting
!
WARNING
!
CAUTION
!
WARNING
1.
Select a safe ground speed when transporting from
one area to another. Maximum transport speed for
the Rotary Cutter is 20 mph. DO NOT EXCEED.
one area to another. Maximum transport speed for
the Rotary Cutter is 20 mph. DO NOT EXCEED.
2.
Be sure to reduce tractor ground speed when turning
and leave enough clearance so the cutter does not
contact obstacles such as buildings, trees, or fences.
and leave enough clearance so the cutter does not
contact obstacles such as buildings, trees, or fences.
3.
Always raise wings and set transport locks before
traveling on public roadways.
traveling on public roadways.
4.
When traveling on roadways, transport in such a way
that faster moving vehicles may pass you safely.
that faster moving vehicles may pass you safely.
5.
Shift tractor to a lower gear when traveling over rough
or hilly terrain.
or hilly terrain.
1
4
3
27921