Land Pride RCB6610 Manuale Utente

11/11/12

Refer to Figure 1-19:
1.

If needed, collapse driveline (#5) by pushing tractor 
end of driveline against splitter gearbox.

2.

Pull back on yoke locking collar (#6) and slide yoke 
over tractor PTO shaft.

3.

Release locking collar (#6) and continue to push 
outer yoke onto tractor PTO shaft until locking collar 
snaps in place.

4.

Both yoke ends of driveline (#5) should be moved 
back and forth to ensure they are secured. Reattach 
yoke end if it is loose.

5.

Rotate driveline hanger (#1) down.

6.

If attached, remove park jack (#3) and store on 
weight box. See steps 13 & 14 on page 16.

1.

Move tractor control lever to extend hydraulic lift 
cylinder (#1) until pressure against stroke control 
spacers (#4) is removed. 

2.

Shut tractor down properly before dismounting. Refer 
to “Tractor Shutdown Procedure” on page 14.

3.

Remove all stroke control spacers (#4) from center 
hydraulic lift cylinder (#1) by spreading them apart at 
the break line.

4.

Start tractor and lower cutter until front skids are 
resting on the ground or on support blocks.

5.

Shut tractor down properly before dismounting.

6.

Replace stroke control spacers (#4) as needed to 
support wheels at this position.

Refer to Figure 1-19:
7.

With driveline attached to tractor, rotate driveline 
hanger (#1) up as shown. 

8.

Loosen nuts securing carriage bolts (#4) and adjust 
driveline hanger (#1) up until there is a small gap 
between driveline (#5) and hanger (#1). 

9.

If driveline hanger (#1) is adjusted fully up and needs 
to adjust higher, remove carriage bolts (#4) and 
reattach hanger to the upper two square holes (#2) 
with existing flat washers, lock washers, hex nuts, 
and carriage bolts (#4). Continue to adjust hanger to 
underside of driveline.

10. Draw nuts securing carriage bolts (#4) up snug and 

rotate driveline hanger (#1) down. If hanger makes 
contact with driveline (#5), readjust hanger down 
until it misses the driveline.

11. Tighten 3/8"-16 GR5 bolts (#4) to the correct torque.

IMPORTANT: Always rotate driveline hanger down 
after hook-up to prevent driveline damage.

12. Rotate driveline hanger (#1) down.

Check driveline for adequate clearance under all ranges 
of cutter height. 

1.

With driveline shaft attached to the tractor and all 
stroke control spacers (#4 in Figure 1-18) removed 
from hydraulic cylinder (#1), slowly raise and lower 
cutter to its upper and lower limits while observing 
clearances between hitch and driveline. 

2.

Adjust tractor drawbar height and/or length if 
driveline interferes. See “Drawbar Set-up” on page 
12 for correct drawbar dimensions.

3.

Cycle cylinders back and forth several times to purge 
cylinders and hydraulic lines of air. For additional 
details, see “Purge Hydraulic System” on page 22.

IMPORTANT: Always rotate driveline hanger down 
after hook-up to prevent driveline damage.

26611

26611

37961