Land Pride RCM4015 Manuale Utente

10/21/15

Refer to Figure 1-22:
Tie down lugs are installed on all four corners of the 
center deck for shipping purposes only. They should be 
removed and discarded before cutter is put into use.

1.

Remove and discard all four shipping lugs (#1) and 
attaching hardware (#2 & #3).

39038

1.

See “Long-term Storage” on page 44 when parking 
the cutter for long periods and at end of season. 

2.

Disengage PTO, park cutter on a level, hard surface. 
Place tractor gear selector in park or set park brake.

Refer to Figure 1-24 on page 23: 

3.

Wait for blades to come to a complete stop and then 
fold wings up to transport position.

4.

Shut tractor engine off and remove switch key before 
dismounting from tractor.

5.

Remove hairpin clips (#1) from storage pins (#2).

Refer to Figure 1-25 on page 23:
6.

Swing transport lock bars (#3) down and place over 
lock pins (#4). Secure with hairpin clips (#1).

7.

Remove all stroke control spacers (#2) from center 
hydraulic cylinder (#1) by spreading them apart at 
the break line.

8.

Start tractor and lower cutter until front skids are 
resting on the ground or on support blocks. 

9.

Shut tractor down properly before dismounting. Refer 
to “Tractor Shutdown Procedure” on page 13.

10. Replace stroke control spacers as needed to support 

wheels at this position.

11. With no one around or near the cutter, move cylinder 

deck and wing cylinder lift levers back and forth to 
release all hydraulic pressure at the couplers.

Refer to Figure 1-27 on page 23: 
12. Remove park jack (#3) from left-hand wing deck and 

attach to jack mount (#12) as shown. Fully insert 
detent pin (#8) in jack mount to secure park jack. 

13. If needed, realign park jack to be vertical. Refer to 

14. Unhook hitch safety chain (#4) from tractor.

15. Unhook hydraulic hoses (#7) from tractor duplex 

outlet. Insert couplers through spring hose loop (#10) 
to keep couplers out of the dirt.

16. Pull back on locking collar (#6) and pull driveline (#5) 

from tractor PTO shaft.

17. Collapse driveline (#5) by pushing tractor end of 

driveline toward the splitter gearbox.

18. Rotate driveline hanger (#11) up to position shown 

and store driveline on hanger.

19. Adjust park jack (#3) as needed and remove 

connecting pin/bolt (#1) from cutter hitch (#9).

20. Restart tractor and drive tractor slowly forward 

several feet.

21. Shut tractor down properly before dismounting. 

22. Lower park jack until cutter is resting on its front skid 

shoes.

23. Continue with instructions on page 23.