Land Pride RCM4015 Manuale Utente

10/21/15

331-498A

Folding Cutter Light Kit 2.5"

The lead wiring harness (#20) is equipped with a 7-way 
round pin connector. Make sure your tractor is equipped 
with the 7-pin electrical outlet shown in Detail C before 
purchasing this product.

1.

Lower cutter center deck and wing decks down until 
unit is resting on the lift cylinder stops and both wings 
are on the ground. 

2.

Shut tractor down properly before dismounting. Refer 
to “Tractor Shutdown Procedure” on page 13.

3.

Move hydraulic control lever back and forth several 
times to release all hydraulic pressure in hydraulic 
lines to the cutter.

4.

On the right-hand wing, remove cotter pin (#10), flat 
washers (#8), transport bar (#1), and clevis pin (#11).

5.

If not done, thread connector (#1A) through 
hole (#21) as shown in Detail A.

6.

Attach right-hand light assembly (#3) under hydraulic 
cylinder (#13) with mounting clamp (#2) on top. 

NOTE:  Hydraulic hoses (#15 & #16) must be 
located above mounting clamps (#2) as shown.

NOTE:  Amber lights are located to the outside and 
red lights are located to the inside as shown.

7.

Nuts (#7) must be on top. Secure unit to cylinder 
with 3/8"-16 x 4" GR5 bolts (#6) and lock nuts (#7). 
Draw lock nuts up snug, do not tighten at this time.

8.

Slide light assembly (#3) and mounting clamp (#2) as 
far as possible toward the rod end of hydraulic 
cylinder (#13).

9.

Tighten each lock nut (#7) one-half turn in a criss-
cross pattern until all nuts are torqued tight. 

10. Replace clevis pin (#11), flat washers (#8), transport 

bar (#1), and cotter pin (#10), Bend one or more legs 
of cotter pin to keep pin (#11) from falling out.

11. Repeat steps 4 thru 10 for the left-hand light 

assembly (#4).

NOTE:  Right-hand wire harness (#17) has a red 
wire showing at both ends. Left-hand harness (#18) 
has a yellow wire showing at both ends.

NOTE:  See Detail B: Pins in the connectors are 
labeled A, B, C, & D. Match yellow and red wires 
with same pin letters when attaching wire harness to 
light assemblies (#3 & #4) & enhance module (#19).

NOTE:  Route wire harnesses (#17, #18, & #20) 
alongside hydraulic hoses. Make sure harnesses 
will not become pinched as the deck is raised and 
lowered and wings are folded up and down.