Land Pride RC35 Series Manuale Utente
19
Section 5 Maintenance and Lubrication
9/25/08
RC15, RC25, and RC35 Series Rotary Cutter 312-298M
Land Pride
4-Plate Slip Clutch
NOTE: Before proceeding, secure the clutch firmly in
a vise or other clamping device to prevent injury.
a vise or other clamping device to prevent injury.
15353
Step 1
Remove snap ring.
Step 2
Remove backup ring, lock collar,
compression spring, bottom backup
ring, and balls.
compression spring, bottom backup
ring, and balls.
Step 3
Tighten the four hex nuts uniformly
until the clutch pack and hub are
loose.
until the clutch pack and hub are
loose.
Step 4
Bend all four retaining lugs out on the
edge of the clutch housing.
edge of the clutch housing.
Step 5
Remove the thrust plate with the
Belleville Springs and lug rings to ac-
cess friction disks and hub for inspec-
tion or service.
Belleville Springs and lug rings to ac-
cess friction disks and hub for inspec-
tion or service.
Step 6
Inspect friction disks and hub.
Step 2
Compress the Belleville Springs to
the pressure plate by tightening the
four hex nuts and then placing the as-
sembly into the clutch housing.
the pressure plate by tightening the
four hex nuts and then placing the as-
sembly into the clutch housing.
Step 3
Bend the retaining lugs inward over
the Belleville Spring edges to secure
the spring before backing the four hex
nuts off.
the Belleville Spring edges to secure
the spring before backing the four hex
nuts off.
Step 4
With the lugs bent in, loosen the four
hex nuts completely to the end of the
threaded studs.
hex nuts completely to the end of the
threaded studs.
Step 5
Insert greased balls.
Step 6
Install bottom backup ring, compres-
sion spring, lock collar, and top back-
up ring.
sion spring, lock collar, and top back-
up ring.
Step 7
Install snap ring.
Step 1
Place the hub and friction disks into
the housing.
the housing.
Disassembly
Assembly
14232