Land Pride RCBM6610 Manuale Utente

11/11/12

There are two ways the constant velocity driveline joints 
shown in Figure 5-16 can be accessed for lubrication. 
One is through holes in the driveline shield and the other 
is to slide the shields back to expose the grease zerks.

1.

Refer to Figure 5-18: Rotate driveline shield until 
holes in shield align with grease zerks in CV joint. 

2.

Apply proper amount and type of lubrication. Refer to 
“CV Main Driveline Joints & Shields” on page 54 
for quantities and type of lubrication.

3.

Refer to Figure 5-19: Rotate driveline shield 180

o

 

until holes on opposite side of shield aligns with 
remaining grease zerks in CV joint.

4.

Repeat step 2 above on any grease zerks that were 
not greased in step 2. 

5.

Steps 1 to 2 can be repeated to lubricate universal 
joint on opposite end of driveline. (Opposite end of 
driveline has only one grease zerk.)

1.

Refer to Figure 5-20: With a flat bladed screwdriver 
or similar tool, pry top of red locking tab up.

2.

Refer to Figure 5-21: Rotate white locking ring fully 
counterclockwise to the position shown.

3.

Refer to Figure 5-22: Pull back on driveline shielding 
until CV joint is exposed.

33992

33993

4.

Apply proper amount and type of lubrication. Refer to 
“CV Main Driveline Joints & Shields” on page 54 
for quantities and type of lubrication.

5.

Slide driveline shield back to its operating position.

6.

Refer to Figure 5-20: Rotate white locking ring 
clockwise and press locking tab down until it snaps in 
place as shown.

7.

Steps 1 to 6 can be repeated to lubricate universal 
joint on opposite end of driveline.

33994

33995

33996