Land Pride 312-753M Manuale Utente
31
Section 4: Maintenance & Lubrication
5/09/08
RCR2596, RCR2510 and RCRM2510 Rotary Cutters 312-753M
Land Pride
Flex Couplers
Refer to Figure 4-6:
Replace rubber disc (#6) as follows:
1.
Insert 3-bolts (#1) through the holes in flange
weldment (#7).
weldment (#7).
2.
Place beaded washers over the 3-bolts with bead
facing rubber disc (#6).
facing rubber disc (#6).
3.
Place bushings (#3), rubber disc (#6) and washers
(#4) over the 3-bolts as shown.
(#4) over the 3-bolts as shown.
4.
Secure with nuts (#5). Do not tighten.
5.
Insert 3-bolts (#1) through the holes in flanged
hub (#8).
hub (#8).
6.
Repeat steps 2 through 4.
7.
Tighten nuts (#5) evenly with nuts torqued 35 to
40 ft-lb. Beaded washers (#2) should be imbedded
halfway into the rubber disc.
40 ft-lb. Beaded washers (#2) should be imbedded
halfway into the rubber disc.
Flex Couplers
Figure 4-6
Skid Shoe Maintenance
Refer to Figure 4-7:
!
WARNING!
Excessive wear on skid shoes may cause inadequate operation
of cutter and create a safety hazard!
of cutter and create a safety hazard!
There are two skid shoes mounted on the cutter sides.
Check both skid shoes for wear and replace if necessary.
Order only genuine Land Pride parts from your local
Land Pride Dealer.
Check both skid shoes for wear and replace if necessary.
Order only genuine Land Pride parts from your local
Land Pride Dealer.
Skid Shoe Replacement
Figure 4-7
22325
22410
1.
Remove 3/8" hex whiz nuts (#3), 3/8" plow bolts (#2)
and skid shoe (#1) as shown.
and skid shoe (#1) as shown.
2.
Plow bolts should be checked for wear and replaced
if necessary.
if necessary.
3.
Attach new skid shoe (#1) to cutter with existing
3/8” plow bolts (#2) and secure with 3/8" hex whiz
nuts. Torque to 31 ft. lbs.
3/8” plow bolts (#2) and secure with 3/8" hex whiz
nuts. Torque to 31 ft. lbs.
4.
Repeat on opposite side.
Tractor Maintenance
One of the most important things you can do to prevent
hydraulic system problems is to ensure that your tractor's
reservoir remains free of dirt and contamination.
hydraulic system problems is to ensure that your tractor's
reservoir remains free of dirt and contamination.
Use a clean cloth to wipe the hose ends before attaching
them to your tractor. Replace the filter element for your
tractor’s hydraulic system at the prescribed intervals.
These simple maintenances will go a long way to prevent
the occurrence of cartridge valve and hydraulic cylinder
problems on the Rotary Cutter.
them to your tractor. Replace the filter element for your
tractor’s hydraulic system at the prescribed intervals.
These simple maintenances will go a long way to prevent
the occurrence of cartridge valve and hydraulic cylinder
problems on the Rotary Cutter.
Storage Instructions
It is good practice to clean off any dirt or grease that may
have accumulated on the cutter and moving parts at the
end of the working season and when the cutter will not be
used for a long time.
have accumulated on the cutter and moving parts at the
end of the working season and when the cutter will not be
used for a long time.
!
DANGER!
Always disconnect main driveline from tractor PTO and secure
cutter deck in the up position with solid supports before
servicing the underside of the cutter.
cutter deck in the up position with solid supports before
servicing the underside of the cutter.
1.
Clean the cutter as necessary.
2.
Check the blades for wear and replace if necessary,
see “Service Cutting Blades”, Page 28.
see “Service Cutting Blades”, Page 28.
3.
Inspect the cutter for loose, damaged or worn parts
and adjust or replace as needed.
and adjust or replace as needed.
4.
Lubricate as noted in “Lubrication”, page 32.
5.
Store the cutter inside if possible for longer cutter life.
6.
Repaint parts where paint is worn or scratched to
prevent rust. Ask your dealer for Aerosol Land Pride
touch-up paints.
prevent rust. Ask your dealer for Aerosol Land Pride
touch-up paints.
Land Pride Skid Shoe Replacement Parts
Part No.
Part Description
312-602D
SKID SHOE
802-603C
PLOW 3/8-16 x 1 GR5
803-198C
NUT HEX WHIZ 3/8-16 PLT
Land Pride Touch-up Paints
Part No.
Part Description
821-011C
PAINT LP BEIGE SPRAY CAN
821-002C
PAINT GP BLACK SPRAY CAN
821-054C
PAINT MEDIUM RED SPRAY CAN
821-058C
PAINT GREEN SPRAY CAN