Land Pride RCD1884 Manuale Utente

12/15/15

Refer to Figure 3-3:
If the front blade tip is set at the desired cutting height and 
the back blade tip is at the same height or lower or is 
higher than the front blade tip by more than 1", then 
tailwheel (#1) must be adjusted up or down as follows:

1.

Use tractor’s 3-Point hydraulic control to lift cutter 
until tailwheels clear the ground.

2.

Remove hex whiz nut (#2) and cap screw (#1).

3.

Adjust tailwheel as follows:

To lower rear blade height, raise tailwheel up.

To increase rear blade height, lower tailwheel 
down. 

4.

With tailwheels adjusted to the correct height, 
replace 1/2"-13 x 4" GR5 cap screw (#1) and hex 
whiz nut (#2). Tighten whiz nut to the correct torque.

5.

Readjust tractor’s lower 3-Point lift arms as needed. 
See “Deck Cutting Height” on page 18.

1.

Lower cutter deck to preset cutting height.

2.

Adjust length of center 3-Point link until the center 
hitch pin is vertically above the lower 3-Point hitch 
pins. The float chain should be hanging loosely when 
adjusted correctly. This arrangement allows for 
optimum ground contour following performance.

3.

Lock center 3-Point link in this position.

NOTE:  The lower bolted-on-bushing in the center 
hitch is used with a quick hitch attachment.

30968

30969

30970