Little Wonder 3/1/1970 Manuale Utente

Pagina di 18
14
LITTLE 
WONDER
BLOWER
STORAGE / TORQUE SPECIFICATIONS
STORAGE
To prevent possible explosion or ignition of vaporized 
fuel, do not store equipment with fuel in tank or 
carburetor in an enclosure with open flame (for example, 
a furnace or water heater pilot).
Before the equipment is put into storage for any 
period exceeding 30 days.
  1.  Drain all fuel from the fuel tank and fuel lines. 
  2.  Start the engine and run until all the fuel is used 
from the carburetor float bowl and the engine 
stops.
  3.  While the engine is still warm, drain the crankcase 
oil and replace with the proper weight oil 
corresponding to the season the equipment will be 
next used.
 4.  Remove the spark plug and squirt a small amount 
of engine oil into the cylinder.  Slowly pull the 
starter a few times to distribute oil in the cylinder 
and reinstall the spark plug.
 5.  Top off if necessary.  See engine manual for 
details.
Location
Description
P/N
Min. Torque 
Ft-lbs (In-lbs)
Max. Torque 
Ft-lbs (In-lbs)
Housing to engine face
BLT-W LF 5/16-24 x 1-3/8
910517
22
28
Engine to deck
BLT 5/16-18 X 1-1/2
64262-009
19
25
Fan to Crankshaft
BLT-HEX 7/16-20 x 1-3/4 GR8
(USED ON 9270 MODELS)
64123-253
50
90
BLT-HEX 3/8-24X1-3/4 GR8
(USED ON 9390 AND 9400 
MODELS)
64123-127
30
50
BLT-HEX 3/8-24 X 2.5 GR 8
(USED ON 9570 MODELS)
64123-267
30
50
To put the equipment into service after an extended 
period of storage.
  1.  Check for loose parts and tighten if necessary. 
  2.  Fill the fuel tank and then check the engine oil 
level.
  3.  Start the engine and check for fuel leaks.  Repair 
any leaks before operating the unit.
TORQUE SPECIFICATIONS