Symbol Technologies LS 3070 Manuale Utente

 

Before its first use, the LS 3070 batteries must be charged. To do so:

 

•

 

Connect the power supply to the power input port on the front panel of 

the RL 470 base/charger, shown in 

 

. 

 

•

 

Connect the power supply to a receptacle supplying AC power of the 

proper voltage level.

 

•

 

Then insert the scanner into the base/charger cradle, so that the nose of 

the scanner and tip of the handle fit snugly into the receptacles. Check the 
charge status indicator (blinking = fully charged) for full charge, which 
occurs within two hours. When fully charged, proceed with pairing.

 

The wireless “connection” between the two is the low power radio 
transmission through RF transceivers in the both the scanner and base/
charger. The actual communication consists of bidirectional message packets. 
However, 

 

 for this communication 

to work between the two devices. 

 

First, the base/charger must be assigned an address, with a value between 01 
and 7E. 

 

. 

