Land Pride BH2585 Manuale Utente
16
Section 1 Assembly and Set-Up
10/28/05
Land Pride
Optional Equipment Assemblies
Locking Bar
Refer to Figure 1-13:
1.
1.
After the backhoe is attached to the tractor in working
position proceed with the following steps to install the
locking bar.
position proceed with the following steps to install the
locking bar.
2.
Assemble eyebolts (#7), lockwashers (#4) and nuts
(#2) as shown. Do not tighten.
(#2) as shown. Do not tighten.
3.
Install pins (#5) through eyebolts (#7) with the
eyebolts being located the inside of backhoe lower link
brackets. Secure pins in place with lynch pins(#6).
eyebolts being located the inside of backhoe lower link
brackets. Secure pins in place with lynch pins(#6).
4.
Adjust the 3/4” bolt against the tractor drawbar link.
5.
Tighten eyebolts with nut and jam nut.
Locking Bar Assembly
Figure 1-13
20598
Tractor’s Lower 3-point
mounts here
Ripper Tooth
Refer to Figure 1-14:
1.
1.
Remove bucket link (#1) by removing pin (#8) and roll
pin (#7) and sliding out links (#2).
pin (#7) and sliding out links (#2).
2.
Assemble ripper tooth assembly with pins and links
from step 1 as shown.
from step 1 as shown.
When the ripper tooth is not needed, the complete ripper
assembly does not need to be disassembled. Remove
pin (#9) and slide the ripper tooth (#3) out and store pin
(#9) back in it’s previous location. The ripper tooth link
(#4) can now be used in place of the bucket link (#1).
assembly does not need to be disassembled. Remove
pin (#9) and slide the ripper tooth (#3) out and store pin
(#9) back in it’s previous location. The ripper tooth link
(#4) can now be used in place of the bucket link (#1).
Ripper Tooth Assembly
Figure 1-14