Cooper Lighting J/FE-CF-03 Dépliant

indicator

When the fixture head is adjusted to the desired angle, re-

an additional 10-degrees.

tighten end screws to secure the position.

Yoke arm indicator

Fixture head

1. To aim fixture, loosen both #10-32 x.625 end screws. When

the PointGrab

system indicators are lined up, the slope

of the lens face is 40-degrees. Each subsequent notch is

#10-32 x 5/8

end screws

(by others)

1/4" Fasteners

Exploded view and part call-out

(by others)

#10-32 x1

Fixture head

End screw

Yoke end cap

fitting

(x3)

Socket cap screw

#6-32 x 5/8

Socket cap screw

(x2)

Yoke

Outdoor J-box

#6-32 x 1/2

1/2" Compression

#6-32 x 1/4

Screw (x2)

Wiring and sealing outdoor fixture

Warning

Visor and Non-Visor

: Before starting any work ensure

that all sources of power are turned off. All

work must meet local/national codes and be

performed by a certified electrician. Do not

Sheet 1 of 2

mount fixtures vertically.

Installation Instructions

Vault

C-Scroll

Roundel

These installation instructions are valid with the above Ametrix styles.

Large, OUTDOOR

YR (30 1/2")

(Yoke mount, Remote ballast)

ADY071449 Rev A (ECN070295)

Yoke end cap

End screw (x2)

#10-32 x 5/8

fasteners (by others).

With fixture head and yoke end cap safely stored, secure

yoke to outdoor surface using four(4) appropriate 1/4"

Mounting yoke to outdoor surface

(by others) (x4)

1/4 Fasteners

1. To secure yoke to outdoor surface, the fixture head must be

removed. First, remove both #10-32 x 5/8 end screws.

2. Remove one #6-32 x 1/4 screw to remove yoke end cap and

fixture head. Place both fixture head and yoke end cap in a

safe place.

#6-32 x 1/4

screw(x2)

Aiming the fixture

(x2)

1/2" Compression

Socket cap screw

#6-32 x 1/2

#6-32 x 5/8

fitting

Socket cap screw

(x3)

1. To seal fixture head, after installing lamp, all screws and

latches must be secured on door face. Holes above latches

receive the #6-32 x 1/2 socket cap screws. The center hole(s)

receive the longer #6-32 x 5/8 socket cap screw.

2. Slide 1/2" compression fitting down fixture head wire and

splice wit power feed, ensuring all connections are properly

matched. Seal 1/2" compression fitting to outdoor surface and

ensure a watertight seal.