Chauvet led par 38 tri-c Manuale Utente

 
LED PAR 38-Tri B&C User Manual 

9 

Rev. 2 

 

You will need a serial data link to run light shows of one or more fixtures using a DMX controller or to 

run synchronized shows on two or more fixtures set to a master/slave operating mode. The combined 

number of channels required by all the fixtures on a serial data link determines the number of fixtures 

the data link can support.  

To link fixtures together you must obtain data cables. You can purchase CHAUVET certified DMX 

cables directly from a dealer/distributor or construct your own cable. If you choose to create your own 

cable please use data-grade cables that can carry a high quality signal and are less prone to 

electromagnetic interference. 

 

 

Each fixture requires a starting address from 1~512. A fixture requiring one or more channels for 

control begins to read the data on the channel indicated by the starting address. For example, a 

fixture that uses seven DMX channels and is addressed to start on DMX channel 100, will read data 

from channels: 100, 101, 102, 103, 104, 105 and 106. Choose the starting addresses for each fixture 

so that the channels used do not overlap. In addition, you should note the starting address selected 

for future reference. 

The LED PAR 38 Tri-B/C

 

fixture uses seven or three DMX channels. If this is your first time using 

DMX, we recommend reading the “DMX Primer” section in the “Appendix”. 

 

Access control panel functions using the four buttons located directly underneath the LED display on 

the included wired remote. 

 
 

 
 
 
 
 
 
 

Used to scroll through the 
current operating mode, 
as well as back out of the 
current menu option 

Used to select decreasing 
advancement in the value 

Used to select increasing 
advancement in the value 

Used to select a value and 
store it to memory