Snapper HWPS26600RV Manuale Utente

 

(Continued From Previous Page) 
3.  Stabilize the machine by placing your left foot on 
the left rear wheel. Machine should be on flat 
surface where footing is secure. 
4. Pull rope start handle to crank engine. Guide 
rope back into engine. DO NOT let it snap back. 
5. After engine starts, move engine speed control 
away from the choke position to the “Fast” (Rabbit) 
position. See Figure 2.3. Refer to Familiarization Page. 
6.  Allow a brief warm-up until engine runs smooth. 
 
2.2.2. BLADE 
NOTE:  The blade control requires two motions to 
engage the blade. 
1.  To engage blade, Lift up on the blade control. 
While lifting up, pull blade control back against 
handle. Blade will engage (rotate). See Figure 2.4. 
2.  Stop blade by releasing blade control. 
 
 
 

 

 

2.2.3.  PROPELLING MOWER (WHEEL DRIVE) 
1.  Move ground speed control to the desired speed 
position. See Figure 2.5. 
2.  Move wheel drive control against handle to 
engage wheel drive and propel mower forward. 
Forward speed can be adjusted while the mower is 
moving by changing position of the ground speed 
control. See Figure 2.5. 
3.  Stop wheel drive by releasing the wheel drive 
control. 

 

 
 
 
 
 
 
 
 
 

 

 

Stop wheel drive by releasing wheel drive control. 
Engine and blade will continue to operate when 
wheel drive control is released. 
 
2.3.2. BLADE 
Stop blade by releasing blade control. Engine will 
continue to operate when blade control is released. 
The engine and the wheel drive can be operated 
with the blade disengaged (OFF). 

 

 
2.3.3. ENGINE 
Stop the engine by moving the engine speed control 
back to the STOP position. 
 
IMPORTANT: Turn fuel valve to “OFF” position 
when machine is not being operated.