Yazoo/Kees ZMKW48192 Manuale Utente

English

-

20

SETUP AND ADJUSTMENTS

1.  Stop the mower and disengage the blades.
2.  Raise the deck height lever to the transport 

position.

3.  Remove the height adjustment pin and place it 

in the desired cutting height hole. Lower the lift 

lever down onto pin. 

NOTE:   Anti-scalp rollers must be in the proper 

position for maximum deck flotation. 

See  the  decal  on  the  front  deck  for 

proper settings.

Lift Lever

Deck Height

Adjustment Plates

1.  Position machine on a flat surface. Preferably 

level concrete.

2.  Check the tire pressure in all four tires. Inflation 

should be 15 psi.

3.  Place 2x4s on edge under the cutting deck 

from front to rear and lower the deck down onto 

2x4s.

4.  Adjust the four upper chain bolts to the center 

slots in the deck lift arms. 

NOTE:   Make  sure  the  lift  blocks  under  the 

frame are tightly bolted to the frame.

5.  Check the chains for equal tension. If unequal 

adjust upper chain bolt in slot.

6.  Place the deck in the 5" cutting height and 

measure from the cutting edge of the blade to 

the flat level surface to check the deck cutting 

height.

Stop engine and remove key.
Throttle lever tension may be adjusted by tightening 

the pivot bolt. The pivot bolt secures the throttle arm to 

the mounting bracket which is mounted to the console. 

Access is gained by removing the console.