Poulan PD20PH48STA Manuale Utente

•      Place attachment clutch in “DIS EN GAGED” position.
•      If  equipped,  turn  height  adjustment  knob  to  low est 

set ting.

•      Lower mower to its lowest position.
•      Disengage belt tension rod from lock bracket.

•      Remove retainer spring holding anti-swaybar to chas sis 

bracket and dis en gage anti-swaybar from bracket.

•      Remove four retainer springs from front plate assembly 

and remove plate.

•      Remove retainer springs from sus pen sion arms at deck 

and dis en gage arms from deck.

•      Raise attachment lift to its highest position.
•      Slide  mower  forward  and  remove  belt  from  electric 

clutch pulley.

•      Slide mower out from under right side of tractor.

Be sure tractor is on level surface and mower suspension 
arms are raised with attachment lift control. Engage park-
 ing brake.
•      Swing anti-sway bar to left side of mower deck.

•      Slide mower under tractor with defl ector shield to right 

side of tractor.

IMPORTANT:  CHECK BELT FOR PROPER ROUTING IN ALL 
MOWER PULLEY GROOVES.  

•      If  equipped,  turn  height  ad just ment knob coun 

ter -

clock wise until it stops.

•      Lower mower linkage with attachment lift control.
•      Be sure belt tension rod is in dis en gaged position.
•      Install belt into electric clutch pulley groove.
•      Place the suspension arms on outward pointing deck 

pins.  Retain with double loop re tain er spring with loops 
up as shown.

•     Install front plate assembly to tractor suspension 

brack ets and retain with single loop retainer springs 
as shown.

•      Position  front  plate  assembly  between  front  mower 

brackets. Raise deck and plate assembly to align holes 
and insert fl anged pins. Secure pins with double loop 
retainer springs between the plate assembly and mower 
brack ets.

NOTE: To assist in locating hole in fl anged pin, the hole in 
pin is inline with notch on head of pin. If necessary, move 
mower side-to-side to give space between plate and mower 
brackets.

IMPORTANT:  CHECK BELT FOR PROPER ROUTING IN ALL 
MOWER PULLEY GROOVES.  

02565