Poulan 186892 Manuale Utente

A socket wrench set will make assembly easier.  Stan dard 
wrench sizes are listed.
(1)  3/4" wrench 

 

Pliers

(2)  7/16" wrenches 

 

Tire pressure gauge

    Utility 

knife

When right or left hand is mentioned in this man ual, it means 
when you are in the operating po si tion (seated be hind the 
steer ing wheel).

•      Remove all accessible loose parts and parts cartons  

from carton.

•     Cut along dotted lines on all four panels of carton. 

Remove end panels and lay side panels fl at.

•     Check for any additional loose parts or cartons and 

remove.

Your new tractor has been assembled at the factory with exception of those parts left unassembled for shipping purposes.  
To ensure safe and proper operation of your tractor all parts and hardware you assemble must be tightened securely.  Use 
the correct tools as necessary to insure proper tightness.

ASSEMBLE EXTENSION SHAFT AND BOOT

•      Slide extension shaft onto lower steering shaft.  Align 

mount ing holes in extension and lower shafts and install 
1/4 hex bolt and lock nut.  Tighten securely.

IMPORTANT: TIGHTEN BOLT AND NUT SECURELY TO 10-12 
FT. LBS TORQUE.
•      Place tabs of steering boot over tab slots in dash and push 

down to secure.

INSTALL STEERING WHEEL

•      Position front wheels of the tractor so they are pointing 

straight forward.

•      Remove  steering  wheel  adapter  from  steering  wheel  and 

slide adapter onto steer ing shaft ex ten sion.

•      Position steering wheel so cross bars are hor i zon tal (left to 

right) and slide inside boot and onto adapt er.

•      Assemble large fl at washer, 1/2 hex nut and tighten se-

 cure ly.

•      Snap steering wheel insert into center of steer ing wheel.
•      Remove protective materials from tractor hood and grill.

IMPORTANT:  CHECK FOR AND RE MOVE ANY STA PLES 
IN SKID THAT MAY PUNC TURE TIRES WHERE TRACTOR
IS TO ROLL OFF SKID.