Poulan 184581 Manuale Utente

Adjust seat before tightening adjustment knob.
•      Remove  adjustment  knob  and  fl at  washer  securing 

seat to cardboard packing and set aside for assembly 
of seat to tractor.

•      Pivot seat upward and remove from the cardboard pack-

ing. Remove the cardboard packing and discard.

•    Place seat on seat pan so head of shoulder bolt is 

positioned over large slotted hole in pan.

•      Push down on seat to engage shoulder bolt in slot and 

pull seat towards rear of tractor.

•      Pivot seat and pan forward and assemble adjustment 

knob and fl at washer loosely. Do not tighten.

•      Lower seat into operating position and sit on seat.
•      Slide  seat  until  a  comfortable  position  is  reached 

which allows you to press clutch/brake pedal all the 
way down.

A socket wrench set will make assembly easier.  Stan dard 
wrench sizes are listed.
Utility knife 

 

 

Pliers

(1)  3/4" wrenches 

 

Tire pressure gauge

(2)  7/16" wrenches 

 

Utility knife

When right or left hand is mentioned in this man ual, it means 
when you are in the operating po si tion (seated be hind the 
steer ing wheel).

•      Remove all accessible loose parts and parts cartons  

from carton .

•      Cut along dotted lines on all four panels of carton. 

Remove end panels and lay side panels fl at.

•     Check for any additional loose parts or cartons and 

remove.

Your new tractor has been assembled at the factory with exception of those parts left unassembled for shipping purposes.  
To ensure safe and proper operation of your tractor all parts and hardware you assemble must be tightened securely.  Use 
the correct tools as necessary to insure proper tightness.

ASSEMBLE EXTENSION SHAFT AND BOOT

•      Slide  extension  shaft  onto  lower  steering  shaft.    Align 

mount ing holes in extension and lower shafts and install 
1/4 hex bolt and lock nut.  Tighten securely.

IMPORTANT: TIGHTEN BOLT AND NUT SECURELY TO 10-12 
FT. LBS TORQUE.
•      Place tabs of steering boot over tab slots in dash and push 

down to secure.

INSTALL STEERING WHEEL

•           Position front wheels of the tractor so they are pointing straight 

forward.

•      Remove  steering  wheel  adapter  from  steering  wheel  and 

slide adapter onto steer ing shaft ex ten sion.

•      Position steering wheel so cross bars are hor i zon tal (left to 

right) and slide inside boot and onto adapt er.

•      Assemble  large  fl at  washer,  1/2  hex  nut  and  tighten  se-

 cure ly.

•      Snap steering wheel insert into center of steer ing wheel.
•      Remove protective materials from tractor hood and grill.

IMPORTANT:  CHECK FOR AND RE 

MOVE ANY STA 

PLES 

IN SKID THAT MAY PUNC 

TURE TIRES WHERE TRACTOR

IS TO ROLL OFF SKID.