Exmark Metro 26 Manuale Utente
18
Cutting Leaves:
• After cutting the lawn, ensure that half of the lawn shows through the cut
leaf cover. You may need to make more than one pass over the leaves.
• For light leaf coverage, set all the wheels at the same cutting height setting.
• If there are more than 5 inches (127 mm) of leaves on the lawn, set the
• If there are more than 5 inches (127 mm) of leaves on the lawn, set the
front cutting height 1 or 2 notches higher than the rear cutting height. This
makes it easier to feed the leaves under the lawn mower deck.
makes it easier to feed the leaves under the lawn mower deck.
• Slow down your mowing speed if the lawn mower does not cut the leave
finely enough.
• If you mow over oak leaves, you can add lime to the grass in the spring to
reduce the acidity of the oak leaves.
4. MAINTENANCE
NOTE: Determine the left and right sides of the machine from the normal operating position.
Recommended Maintenance Schedule
Service Interval
Maintenance Procedure
Each Use
• Check the engine oil level.
• Check the stopping time of the blade brake. The blade must stop
within 3 seconds of releasing the bail; if it does not; contact an
Authorized Service Dealer for repair.
Authorized Service Dealer for repair.
• Remove grass clippings and dirt from under the housing.
• Clean the discharge tunnel area
8 Hours
• Check the blade and the engine mounting fasteners. Tighten them
if they are loose.
• Check BBC tension.
50 Hours
• Change the engine oil (without the oil filter).
1
• Sharpen or replace the blade; maintain it more frequently if the
edge dulls quickly in rough or in sandy conditions.
• Clean the blade brake clutch shield.
• Check for leaks in the fuel system and/or a deteriorating fuel hose.
Replace parts if necessary.
• Remove grass clippings and debris from under the belt cover.
• Lubricate the gear case.
• Lubricate the pivot arms.
75 Hours
• Adjust the self-propel drive system.
100 Hours
• Change the oil filter.
• Inspect the spark plug and replace it if necessary.
• Clean the cooling system; remove grass clippings, debris, or dirt
from the engine air cooling fins and starter. Clean the system more
frequently in dirty or high-chaff conditions.
frequently in dirty or high-chaff conditions.
• Adjust the blade brake cable.
• Service the wheels.
300 Hours
• Replace the paper air filter. Replace it more frequently in dusty
operating conditions.
Storage
• Empty the fuel tank before repairs as directed or before storage.
1
Change the engine oil after the first 5 operating hours.
NOTE: Refer to your engine operator’s manual for additional maintenance procedures.