Husqvarna Z 242F Manuale Utente

14

CONTROLS

The 20 amp primary fuse is located on the left hand side of the 
machine. It is accessed by tilting the seat forward. The fuse is 
a flat pin type used in automobiles.

The fuel shut off valve is located at the right rear of the seat. 
The valve is off when the handle tab is turned perpendicular to 
the fuel line.

The seat can be adjusted lengthways. When making 
adjustments, the lever under the right side of the seat is pulled 
up, after which the seat can be moved backward or forward.

IMPORTANT INFORMATION  To obtain an even cutting 
height, it is important that the air pressure in all tires is 15 
psi / 103 kPa / 1 bar.

IMPORTANT INFORMATION  Always raise the deck to the 
highest position for transport.

To set the deck cutting height, pull the cutting height lever 
inwards and move it to the desired height notch.

  WARNING! 

 Bypass linkages are located close to 

the muffler. To prevent burns, the engine should be shut off 
and allowed to cool before the bypass linkage levers are 
handled.

Transaxle bypass linkages must be engaged when pushing or 
pulling the mower. The release levers are located on each side 
of the rear of the unit below the rear engine guard. See Moving 
Machine By Hand in the Operation section.