Husqvarna 5521 CHV 96143000106 Manuale Utente

6.    Wait one minute to allow oil to settle.  Use guage on oil 

fi ll cap/dipstick for checking level.  Insert dipstick into 
the tube and rest the oil fi ll cap on the tube.  DO NOT 
thread the cap into the tube when taking reading.

See “TO ADJUST CUTTING HEIGHT” in the Operation 
section of this manual.

The rear defl ector, attached between the rear wheels of 
your mower, is provided to minimize the possibility that 
objects will be thrown out of the rear of the mower into 
the operator's mowing position.  If the defl ector becomes 
damaged, it should be replaced.

7.    Continue adding small amounts of oil and rechecking 

the dipstick until it reads full.  DO NOT overfi ll, or engine 
will smoke on startup.

8.    Always be sure to retighten oil dipstick before starting 

engine.

9.    Reconnect spark plug wire to spark plug.

Your engine will not run properly and may be damaged 
by using a dirty air fi lter. Replace the air fi lter every 100 
hours of operation or every season, whichever occurs fi rst. 
Service air cleaner more often under dusty conditions.  See 
the main tenance section of your engine manual.

Inspect and replace corroded muffl er as it could create a 
fi re hazard and/or damage.

Replace spark plug at the beginning of each mowing season 
or after every 100 hours of operation, whichever occurs 
fi rst.  Spark plug type and gap setting are shown in the 
“PRODUCT SPEC IFICA TIONS” section of this manual.

IMPORTANT:  FOR BEST PERFORMANCE, KEEP MOWER 
HOUSING FREE OF BUILT-UP GRASS AND TRASH.  CLEAN 
THE UNDERSIDE OF YOUR MOWER AFTER EACH USE.

•      Clean the underside of your lawn mower by scraping 

to remove build-up of grass and trash.

•         Clean engine often to keep trash from accumulating.  A 

clogged engine runs hotter and shortens engine life.

•      Keep fi nished surfaces/wheels free of all gasoline, oil, etc.

•      We do not recommend using a garden hose to clean 

lawn mower unless the electrical system, muffl er, air 
fi lter and carburetor are covered to keep water out. 
Water in engine can result in shortened engine life.

Clean under drive cover at least twice a season. Scrape un-
derside of cover with putty knife or similar tool to remove any 
build-up of trash or grass on underside of drive cover.

1.    Remove drive cover and belt keeper.