Husqvarna LOYTH20F42T Manuale Utente

20

WARNING:  TO AVOID SERIOUS INJURY, BEFORE PERFORMING ANY SER-
 VICE OR ADJUSTMENTS:
1.   Depress brake pedal fully and set parking brake.
2.   Place attachment clutch  in “DISENGAGED” position.
3.   Turn ignition key to “STOP” and remove key.
4.   Make sure the blades and all moving parts have completely stopped.
5.   Disconnect spark plug wire from spark plug and place wire where it cannot 

come in contact with plug.

1.   Place attachment clutch in “DIS EN -

GAGED” position.

2.   Lower attachment lift lever to its lowest 

position.

3.   Remove mower belt from electric 

clutch pulley (M).

4.   Disconnect front link (E) from mower 

- remove retainer spring and washer.

5.   Go to either side of mower and discon-

nect mower suspension arm (A) from 
chassis and rear lift link (C) from rear 
mower bracket (D) - remove retainer 
springs and washers. 

6.   Go to other side of mower and discon-

nect the suspension arm and rear lift 
link.

  CAUTION: After rear lift links are dis-

connected, the attachment lift lever will be 
spring loaded. Have a tight grip on lift lever 
when changing position of the lever.
7.   Slide mower out from under right side 

of tractor.

Be sure tractor is on level surface and 
engage park ing brake.
1.   Lower attachment lift lever to it's lowest 

position.

  CAUTION: Lift lever is spring loaded. 

Have a tight grip on lift lever, lower it 
slowly and engage in lowest position.

NOTE: Be sure mower side suspension 
arms (A) are pointing forward before slid-
ing mower under tractor.
2.   Slide mower under tractor until it is 

centered under tractor. 

3.   ATTACH MOWER SIDE SUSPENSION 

ARMS (A) TO CHASSIS - Position hole 
in arm over pin (B) on outside of tractor 
chassis and secure with washer and 
retainer spring.

4.   Repeat on opposite side of tractor.