Wright Manufacturing 3228-33 Manuale Utente
14
OFF
ON
3.3 Digital Hour Meter
The Stander is equipped with a digital hour meter. Refer to operating/reset instructions below.
The programming specified is:
Default display: Hours
Press once (TMR1): Timer 1, press for 3 sec to reset
Press twice (TMR2): Timer 2, press for 3 sec to reset
Press three times (svc ENG): Will display time remaining until next
service point, hold down to reset. The first interval is 8hr, thereafter
100hr. Beginning 5hr before service point the meter will flash “svc
ENG, in [remaining hours]” every 5 sec.
Shut off engine: Will display how many times the engine has
started.
The programming specified is:
Default display: Hours
Press once (TMR1): Timer 1, press for 3 sec to reset
Press twice (TMR2): Timer 2, press for 3 sec to reset
Press three times (svc ENG): Will display time remaining until next
service point, hold down to reset. The first interval is 8hr, thereafter
100hr. Beginning 5hr before service point the meter will flash “svc
ENG, in [remaining hours]” every 5 sec.
Shut off engine: Will display how many times the engine has
started.
3.4 Model & Serial Location
1- The plate is affixed to the rear of the engine deck in between
the hydro pumps.
2- Stated on the plate will be the model and serial number, these
will be needed when ordering parts.
3.5 Fuel System / Shut-Off Valve
The fuel shut-off valve and fuel gauge is located on top of the fuel tank. The valve should be in the “OFF”
position at all times when the mower is not in use. Do Not fill the tank completely. Fill level is 1 inch below the
bottom of the fill neck. This will allow for the gas to expand.
position at all times when the mower is not in use. Do Not fill the tank completely. Fill level is 1 inch below the
bottom of the fill neck. This will allow for the gas to expand.