Kärcher K 6.55 M Manuale Utente
![Kärcher](https://files.manualsbrain.com/attachments/96f364d058926f8e2e15f015ff2deb64f1b5a423/common/fit/150/50/0378c6636f008948da7ffa032d925e63a9401edd354d99aa9d6aad9342c5/brand_logo.jpeg)
4
IMPORTANT PRECAUTIONS – continued
ASSEMBLY INSTRUCTIONS
• Never use the pressure washer to draw in
water contaminated with solvents, e.g.
paint thinners, gasoline, oil, etc.
NOTE: Dirt in the feed water will
damage the unit. To avoid this risk,
we recommend fitting a water filter.
paint thinners, gasoline, oil, etc.
NOTE: Dirt in the feed water will
damage the unit. To avoid this risk,
we recommend fitting a water filter.
• Always prevent debris from being drawn into
the unit by using a clean water source and an
accessory water filter if required.
accessory water filter if required.
Water Supply
(Cold Water Only)
• Water hose must be at least a 1/2 inch or
5/8 inch in diameter.
• Flow rate of water supply must not fall
below 2 GPM (gallons per minute).
• Flow rate can be determined by running the
water for one minute into an empty 5-gallon
container.
container.
• The water supply temperature must not
exceed 104°F/40°C.
Step 1
Attach the handle to the frame
of the pressure washer. Align
holes, insert bolts, and
thighten with the knobs.
Attach the handle to the frame
of the pressure washer. Align
holes, insert bolts, and
thighten with the knobs.
Step 2
Attach the gun/hose storage
handle.
Attach the gun/hose storage
handle.
Step 3
Insert the detergent tray into
the slot.
Insert the detergent tray into
the slot.
Step 5
Pull out the locking slide from
the right side of the trigger gun
handle. Insert the small end of
the high pressure hose into
place.
Pull out the locking slide from
the right side of the trigger gun
handle. Insert the small end of
the high pressure hose into
place.
Step 6
Push the locking slide back into
the trigger gun to lock the hose
in position.
Push the locking slide back into
the trigger gun to lock the hose
in position.
Step 4
Screw in the fastener.
Screw in the fastener.