Generac 6565 Manuale Utente
17
HOW TO START YOUR POWER WASHER
NOTE:
DO NOT run the pump without the water supply connected and
turned on. Damage to the equipment resulting from failure to
follow these instructions will void warranty.
1. Move the fuel valve lever to the ON position (Figure 24).
Figure 24 – Fuel Valve
Off
On
2. Move
the
choke lever to
the
“CLOSE” position (Figure 25).
NOTE:
For a warm engine, be sure the choke lever is in the “OPEN”
position.
Figure 25 – Choke Lever
Choke
Close
Open
3. Move
the
throttle control lever to
the
“HIGH” position, shown
on
the
engine as a rabbit (Figure 26).
Figure 26 – Throttle Control
High
Low
4. Turn the engine switch to the "ON" position (Figure 27).
Figure 27 – The ON Position
OFF
ON
IMPORTANT: Before starting the power washer, be sure you are
wearing adequate safety goggles.
Risk of eye injury. Spray can splash back or propel
objects.
• Always wear safety goggles when using this equipment or in the
vicinity of equipment in use.
• Before starting the power washer, be sure you are wearing
adequate safety goggles.
• NEVER substitute safety glasses for safety goggles.
5. Place foot on footpad or otherwise secure the unit from
movement when pulling the recoil.
6. When starting the engine, grasp the starter grip handle (Figure
28) and pull slowly until you feel some resistance. Then pull
rapidly to start engine.
Operation