Curtis 3000 Manuale Utente

     1.   PRELIMINARY:   Remove and store the original equipment front skid / splash pan and the 

two longitudinal channel struts bolted between the blocker beam (just behind the front 

bumper) and the front suspension cross member.  Remove the three nuts from the 

bumper attaching bolts at the front of each frame rail.  Save all the original equipment 

fasteners, some will be used to attach the plow mounting, save the remainder for 

possible reinstallation if the plow mounting is removed.  The skid / splash pan and 

longitudinal  st 

           Leave all fasteners loose or “finger tight” until all components have been installed onto the 

vehicle or until installation instructions specify to do so.      

2.  MOUNTING FRAME:  Lift the mounting frame (1) up under the front of the vehicle with 

the slotted holes in the front brackets over the six bumper attaching bolts at the front of 

the frame rails.  Fasten using the six original equipment nuts removed previously.  Fasten 

the rear push angles of the mounting frame (1) to the threaded holes (that the rear of the 

longitudinal struts were attached to) in the front suspension cross member using four of 

the original equipment fasteners.  Tighten all fasteners fully.

 

3.   FINAL  ASSEMBLY AND INSPECTION:  Inspect the mounting attachment bolts to be 

certain that they are all in place and that they are all tight.

OPTIONAL: PLUG MOUNT BRACKET INSTALLATION:  Install the Plug Mount Bracket if the harness will 

be mounted on the frame kit, otherwise, the harness may be routed through the grill, bumper, etc…  Using 

(2) 10-32 x 3⁄4” hex bolts and nylon locknuts, fasten the Plug Mount Bracket to the Plug Mount Bracket 

Mounting Tab located on the drivers side of the frame kit receiver.  The included 8-32 hardware is used for 

mounting the hi-amp battery leads to the Plug Mount Bracket, if used.