Ariens 932038 - 5520 Manuale Utente

GB - 19

IMPORTANT: Wipe each fitting clean before 
and after lubrication.
IMPORTANT: DO NOT allow grease or oil to 
get on friction disc, friction plate or belts.
NOTE: Apply Stens Mix Hi-Temp Grease or 
equivalent to the lubrication fittings. See 
Service Parts.
Sno-Thro should be lubricated (Figure 12) at 
beginning of season or every 25 operating 
hours.

NOTE: To grease auger shaft, remove shear 
bolt nuts, and shear bolts. Turn auger on shaft 
while applying grease at zerk fittings. Replace 
shear bolt per instructions in Service and 
Adjustments.

Deflector must stay in selected position while 
throwing snow. 
To adjust, loosen then retighten hardware to 
desired deflector drag force (Figure 13).

If chute does not stay in position while 
operating, tighten nut on carriage bolt at pivot 
point to increase tension on spring (Figure 14).

OS1373

Grease

Oil

Figure 12

WARNING: AVOID INJURY. Read 
and understand the entire Safety 
section before proceeding.

Adjusting 
Hardware

OS0113

Discharge Chute 
Deflector

Figure 13