Bolens 2N1 Manuale Di Servizio

1.  Remove packing material, if present. 
2.  Raise the upper handle in the direction shown in 

Figure 3-1 until it clicks into the operating position.  
Make sure not to pinch or crimp the cable.

3.  Tighten the knobs. See Figure 3-2.

NOTE: All references 
to left or right side of 
the snow thrower is 
from the operating 
position only.

NOTE: This Operator’s 
Manual covers several 
models.
Not all features refer-
enced in this manual 
are applicable to all 
snow thrower models.

Do not use the 

chute handle to lift 

the snow thrower.

Rotate the discharge chute to the left or right using chute 
handle. 

The angle of the discharge chute controls the 

distance that the snow is thrown. Tilt the discharge chute 
up for greater distance; tilt down for less distance. See 
Figure 3-3.
Loosen the hand knob on the side of the discharge chute 
to adjust. Tilt the chute to the desired position, and tighten 
the knob.

IMPORTANT:  Do not use the chute handle to lift the 
snow thrower