Cub Cadet 724WE Manuale Utente

16

•

Tip the snow thrower up and forward, so that it rests 
on the housing.

•

Remove six self-tapping screws from the frame 
cover underneath the snow thrower.

•

Remove the click pins which secure the wheels, 
and remove the wheels from the axle.

•

Using a 7/8" wrench to hold the shaft, loosen, but 
do not completely remove, the hex nut and bell 
washer on the left end of gear shaft. See Figure 21.

•

Lightly tap the hex nut to dislodge the ball bearing 
from the right side of frame before removing the hex 
nut and bell washer from left end of shaft.

•

Move the gear shaft to the right and slide the friction 
wheel assembly from the shaft.

•

Remove the six screws from the friction wheel 
assembly (three from each side). Remove the 
friction wheel rubber from between the friction 
wheel plates. See Figure 22.

•

Reassemble new friction wheel rubber to the 
friction wheel plates and hub, tightening the six 
screws in rotation and with equal force.

NOTE:  Snow thrower shown resting on its
auger housing. Wheels not shown for clarity.