Echo 99944200532 Manuale Utente

Before operation a complete check of the unit must be performed; 

•  Check unit for loose/missing nuts, bolts and screws. Tighten and/or replace as needed.                                         

Locate this safety decal on  your attachment. Make sure the decal is legible and that you understand and follow the 

instructions on it. If it cannot be read, a new one can be ordered from your ECHO dealer.  See PARTS ORDERING 

instructions for specific information.

1.  GRIP, FRONT - Cushioned grip for left hand.

2.  SHAFT DECAL - Contain important safety information that must be followed.

3.  LOWER DRIVE SHAFT ASSEMBLy - Contains a specially designed liner and the flexible drive shaft.

4.  CUTTING ATTACHMENT - Sealed, gear ratio is 1.5:1 reduction.

5.  AUTOMATIC OILER ASSEMBLy - Self oiling. Use high quality, low viscosity, non  detergent bar and chain oil.

6.  SAW CHAIN -  91 VX  9.53mm (3/8 inch) low profile Oregon® saw chain. Runs approximately 725 m/min.                  

(2378 ft/min) at 6500 RPM.

7.  GUIDE BAR - 254 mm (10 inch) Bar

8.  CUTTING SHOE - Used to capture and stabilize branch while cutting.  Place cutting shoe against branch, accelerate 

and lower saw chain into branch. 

9.  GUIDE BAR COVER -  Used to cover guide bar and saw chain during transport and storage. Remove guide bar 

cover before using unit.

Moving parts can amputate fingers or cause severe injuries.  Keep hands, clothing and loose objects away from all 

openings.     

•  ALWAyS stop engine, disconnect spark plug, and make sure all moving parts have come to a complete stop  

before removing obstructions, clearing debris, or servicing unit.

•  DO NOT start or operate unit unless all guards and protective covers are properly assembled to unit.

•  NEVER reach into any opening while the engine is running.  Moving parts may not be visible through openings.