Azden 105ULH Manuale Utente

Thank you for purchasing Azden’s 105 wireless microphone system. Depending on which 

system your ordered, this package will contain one or more of the following components: 

the 105UPR receiver, the 15BT body-pack receiver with EX-503L lavalier microphone, the 

15XT Plug-in transmitter and/or the 15HT handheld microphone/transmitter. This equip-

ment is designed primarily for video cameras but can be used with most electronic com-

ponents having a microphone level input. The 105UPR allows you to “receive” audio from 

one transmitter at a time.

(1) Remove the battery compartment lid by sliding it down.

(2) Insert two fresh Alkaline “AA” batteries into the compartment. Make sure the battery 

polarity is correct as marked inside the battery compartment.

(3) POWER

 

Switches the receiver “ON” and “OFF”

(4) MIC OUT jack

 

The 105UPR is supplied with a mini-to-mini cable.

 

For mini jack microphone inputs: Use the supplied mini-to-mini cable.  

 

 

Plug one end of the cable into the receiver and the other end of the    

 

 

cable into the microphone input on the video camera.

 

For 3-pin XLR microphone inputs: Use the optional mini-to XLR  

 

 

 

cable (MX-1). Plug the mini-plug end of the cable into the    

 

 

 

receiver (use the screw-down sleeve to secure it to the receiver) and   

 

 

plug the XLR end of the cable into the microphone input of   

 

 

 

the video  camera.

(5) Frequency Selection

 

Frequency adjustment is accomplished by setting the controls inside the bat-   

 

tery compartment. With the frequency GROUP dial on the left (column A on    

 

the included chart) you can select any of 10 frequency groups (numbered 0-9).   

 

With the frequency CHANNEL dial on the right (column B on the  

 

 

 

included chart) you can select any of 10 frequency channels (numbered 0-9).    

 

There are actually 92 possible selections.

(6) Phone Jack

 

Plug the earphone into this jack to monitor the sound. The jack is wired to work  

 

with either a mono or stereo headphone (you will hear mono in both ears when   

 

using a stereo headphone).

(7) LED indicator

 

This LED turns RED when the receive is turned “ON” and GREEN when  

 

 

receiving a signal from the transmitter.

(25) Remove the battery compartment cover by rotating it counterclockwise and  

 

sliding it down.

(26) Insert two fresh Alkaline “AA” batteries into the compartment. Make sure the  

 

battery polarity is correct as marked inside the battery compartment.

Inside the battery compartment you will also find #27 and #28

(27) MIC LEVEL Control

 

The MIC LEVEL control enables you to adjust the audio level of the micro 

 

 

phone. Using the supplied tool, turn the dial clockwise to increase, or   

 

 

counterclockwise to decrease the microphone’s audio output level.

(28) Frequency Selection

 

Frequency adjustment is accomplished by setting the controls inside the bat-   

 

tery compartment. With the frequency GROUP dial on the left (column A on    

 

the included chart) you can select any of 10 frequency groups (numbered 0-9).   

 

With the frequency CHANNEL dial on the right (column B on the  

 

 

 

included chart) you can select any of 10 frequency channels (numbered 0-9).    

 

There are actually 92 possible selections.